[Elecraft] K3 SSB

[Stewart Baker]

Enough gain for low output microphones, selectable input Z, good RF immunity ?

73
Stewart G3RXQ
On Thu, 21 Jun 2007 12:14:17 -0700, Lyle Johnson wrote:
>> OK, I have to ask...I don't see a FAQ for SSB under the mode banner on the
>>
>> Elecraft site.
>> So, what are the expectations for this rig as a voice contest radio?
>>
> Briefly, it has VOX, Anti-VOX and PTT to activate SSB Tx.  It has an
> 8-band Tx Equalizer.  It's capable of ESSB for those who wish to do so.
> It has High-Cut and Low-Cut controls to make it easy to adjust receive
> selectivity.  Manual as well as auto-notch.  Denoiser.  Optional digital
> voice recorder.  Adjustable IF clipper for increased talk power under
> marginal conditions.  Monitoring of Tx audio so you can hear what your
> signal will sound like over the air.  Isolated soundcard interface so
> you can use a PC for voice-mode operation.  Front and rear panel
> microphone jacks.  Switchable mic bias (on/off) to accommodate electret
> or other microphones on a per-jack basis.
>
> Etc.  The "etc" are always important ;-)
>
> 73,
>
> Lyle KK7P
>
>