[Elecraft] K2 SSB Option RP3 Question

[Geoffrey Mackenzie-Kennedy]

Ooops - KSB2 should have read K2! Sorry.

73,
Geoff
GM4ESD

----- Original Message ----- 
From: "Geoffrey Mackenzie-Kennedy" <gmk at gm4esd.fsworld.co.uk>
To: "Elecraft Discussion List" <elecraft at mailman.qth.net>
Sent: Saturday, June 16, 2007 3:46 PM
Subject: Re: [Elecraft] K2 SSB Option RP3 Question


> Clark, I do not have my manual for the KSB2 here but you could try 
> measuring
> the resistance between pins and see if the results agree with the values
> shown in the schematic. If they do and the physical size is OK I would use
> it, but you might like to get a second opinion before doing so.
>
> 73,
> Geoff
> GM4ESD
>
>
> Clark Macaulay <clarkmacaulay at yahoo.com> wrote:
>
>> I'm buidling my K2 purchased at Dayton and found a problem when doing a 
>> parts inventory.  The Parts List designator for RP3 is far different than 
>> the part I received: it says 806345.  Does anyone know if this is a 
>> acceptable substitute?  There's nothing in the manual/Addenda nor in the 
>> reflector archives.
>