[Elecraft] first snag

[KU4YP]

    hello all, 

 

            Well, I hit my first snag with k2 # 5723. 

 

            On page 61 of the manual in the vco alignment, I measured the
voltage of r30 first out at 2.33. that was with the tuning slug, L30 turned
all the way in. turning the slug out the voltage changed to 2.44. this is no
where near the 6 volts. My question is, the manual says if the voltage does
not change, refer to troubleshooting. I can't find anything in
troubleshooting that refers to this. With the small change, I am afraid I
will need to rewind t5. 

 

            Anyone have the same problem? Words of wisdom in winding t5/

 

            73 mike ku4yp