[Elecraft] Got K2, many questions...

[Paul Fletcher]

>I don't have the frequency counter test cable mentioned in the CAL FIL
>section, at least I don't think I do.

You need the counter probe to adjust the filters and it needs to be
connected. Check it's not inside the K2 - it's a short piece of coax with a
two pin header on one end and a single pin connector on the other. The
procedure is in the manual which you can download if you don't have it.
 
>The coax is connected to the ANTENNA  BNC instead of ANT1 or ANT2. 

You must use ANT1 or ANT2 if the ATU is in place

>I might want to use the KAT2 in the field and KPA100 at home.

It takes about 2 minutes to swap the KPA100 for the QRP top cover. All
connections are plug/sockets

Hope this helps.

Regards,
Paul M1PAF