[Elecraft] K3/10 OUTPUT POWER

[Bob Nielsen]

It would certainly violate the FCC's requirement in 97.317 of 15 dB  
maximum gain (although with the loosening of amp restrictions I can't  
understand why they left that one in place).

Bob, N7XY

On Jul 3, 2007, at 7:03 AM, Joe-aa4nn wrote:

> Drive power for the Expert 1K-FA amplifier
> is "Typically 20W"  for full output.  Typically.
> I would think it ambitious to expect full output
> with just 20 watts drive.  Just my opinion.
> de Joe, aa4nn
> .
> ----- Original Message ----- From: "Dale Parfitt" <parinc at verizon.net>
> To: <elecraft at mailman.qth.net>
> Sent: Tuesday, July 03, 2007 9:46 AM
> Subject: [Elecraft] K3/10 OUTPUT POWER
>
>
>> I have one of the new SPE Expert amps on order:
>> http://www.linear-amp.com/
>>
>> It requires 20W of drive for full output. Can one of the  
>> knowledgeable K3 designers/testers comment on nominal Po from 160-- 
>> >6M?
>>
>> Tnx,
>> Dale W4OP
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>