[Elecraft] K3/10 OUTPUT POWER

[ab7r at cablespeed.com]

I've been seeing about 14-15 watts but have not checked on 6m yet.  Will do so this 
evening and report back.

So far every contact has reported a very nice clean signal.  Excellent CW note and 
audio quality using the 2.8 kHz filter for SSB TX.  The TX EQ really makes a 
difference as well.

-------------------------
73,
Greg - AB7R
Whidbey Island WA
NA-065

On Tue Jul  3  9:46 , "Dale Parfitt"  sent:

>I have one of the new SPE Expert amps on order:
>http://www.linear-amp.com/
>
>It requires 20W of drive for full output. Can one of the knowledgeable K3 
>designers/testers comment on nominal Po from 160-->6M?
>
>Tnx,
>Dale W4OP 
>
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com