[Elecraft] Mobile K2/100? with detached control head??

[Howard W. Ashcraft]

I am considering modifying my K2/100 for mobile operation.  Ideally, I
would detach the front panel and control board and mount them in the
dash or near the driver with the remaining transceiver pieces in the
rear of my SUV in a modified EC2.  The SUV radio/CD player has an
auxiliary input, so I will probably pipe the audio into the built-in to
provide sufficient audio for mobile ops.  ( I may need/want to build a
small pre-amp/audio out to match the impedance/level of the audio input
in the SUV.  Does anyone know what the standard level/impedance is for
an "AUX" connection?

Before sitting down and figuring how to accomplish this task, I thought
I would ask if anyone has undertaken a similar project and if there were
any unusual difficulties.  (The good/bad news is that I won't actually
undertake this project until a K3 arrives, so I have time to consider
how this should be accomplished....)

73,

Howard W1WF



*****************************
This communication, including any attachments, is confidential and may be protected by privilege.  If you are not the intended recipient, any use, dissemination, distribution, or copying of this communication is strictly prohibited.  If you have received this communication in error, please immediately notify the sender by telephone or email, and permanently delete all copies, electronic or other, you may have.

To ensure compliance with requirements imposed by the IRS, we inform you that any tax advice contained in this communication (including any attachments) was not intended or written to be used, and cannot be used, for the purpose of (i) avoiding penalties under the Internal Revenue Code or (ii) promoting, marketing or recommending to another party any transaction or matter addressed herein.

The foregoing applies even if this notice is embedded in a message that is forwarded or attached. 
*****************************