[Elecraft] XV144 transverter question

[Dave Blaschke]

Hi John,

I mis-spoke. I meant to say that I want the 28 mhz receive out of the 
transverter, not the 144 mhz receive, while keeping the 144 mhz RX/TX 
on the single output port connector.




At 02:08 1/31/2007, you wrote:
>I suppose you could install W2, but I think you'd end up with
>impedance issues. You're better off removing the T/R relay and using
>an external relay, with a correctly designed network (and probably a
>gain stage to compensate for the lost dbs) ..
>
>or, you could do it on the 28Mhz side .. that's what I'm planning on
>doing this spring :)
>
>de w1rt/john
>
>On 1/30/07, Dave Blaschke <w5un at wt.net> wrote:
>>My transverter is set up to TX and RX on the same output connector.
>>Is it possible to configure so that I can retain this RX/TX as is and
>>have another port give me 144 mHz RX only output? I need this
>>capability in order to interface the transverter to my SDR-IQ SDR,
>>which is a receive only radio.
>>
>>
>>_______________________________________________
>>Elecraft mailing list
>>Post to: Elecraft at mailman.qth.net
>>You must be a subscriber to post to the list.
>>Subscriber Info (Addr. Change, sub, unsub etc.):
>>  http://mailman.qth.net/mailman/listinfo/elecraft
>>
>>Help: http://mailman.qth.net/subscribers.htm
>>Elecraft web page: http://www.elecraft.com
>