[Elecraft] KPA100 and RFC6, etc

[Ron D'Eau Claire]

See this info on the Elecraft web site.

http://www.elecraft.com/Apps/Builder%20Alert%20Installing%20Small%20Chokes%2
0Rev%20B.pdf

Or, for a short URL:

http://tinyurl.com/yvm7vk


Ron AC7AC

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Jeff Kinzli
Sent: Monday, January 29, 2007 9:16 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] KPA100 and RFC6, etc


Hey guys,

I'm working on KPA100, and at the step to install RFC6 and others. The board
outlines and holes are for miniatures, but the only miniature I got was
RFC9. Is it ok to bend the leads on the larger chokes to bend underneath the
choke to make the holes? If I do this, the choke is about 0.25" off the
board, is that ok?

Thanks,

-Jeff
_