[Elecraft] Errata Step 2

[David Wilburn]

Errata Step 2 states;
2. Page 47, right column, 2nd assembly step: This step was supposed to 
be on page 64, right column, just before "Assembly, Part III". Make a 
note on page 64 referring to the step on page 47.


Is this the section it is referring too?  They are wanting you to do 
this before Assembly III?  I can't make any sense out of linking page 
64, which is starting an assembly process, to page 47?

***If you have an Elecraft XG1 receiver test oscillator or other
calibrated signal source, set it for 50 microvolts (-73 dBm) and
verify that the S-meter indicates S-9. If not, adjust C A L S H I .****
-- 

David Wilburn
dave.wilburn at verizon.net
K4DGW