[Elecraft] T2gen

[Don Wilhelm]

You must know which pin you have connected the AF signal to at the
microphone configuration header.  Perhaps your KSB2 manual and your mic type
will help you recall - for the Elecraft mics (and Kenwood) that will be pin
1.  Similarly, you must also know which mic jack pins are connected to
ground - choose one of the ground pins if there are multiples.

Connect the output of the T2Gen to the AF and grround pins on the mic jack -
yes that is easiest to do if you use an 8 pin mic plug.

Once connected, follow the instructions in the T2Gen manual to balance the
tones and obtain the correct input level.  Observe the result on a 'scope or
a spectrum analyzer.

73,
Don W3FPR

> -----Original Message-----

>
> Can someone assist me in hooking up this to mic input?Do I get another new
> mic connector and put a pin on back side of plug at mic input and go from
> there?Learning how to use this device.  Tnx

--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.432 / Virus Database: 268.17.10/651 - Release Date: 1/24/2007
6:48 PM