[Elecraft] control board construction

[Dohn]

There is a small, rectangular, black plastic jumper with 2 holes in it.  You
slide that over the indicated pins of P7.  It is the easiest of the jumpers
to place.  Look for that little, black mystery part.  There is a pic of it
in appendix A - page 4, next to the last item.

Good Luck and go slow

Dohn N8EWY

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Dennis Vavra
Sent: Saturday, January 06, 2007 10:06 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] control board construction

I need some clarification for the installation of a "shorting jumper" for
part P7 on the control board. the instructions are on page 17, right-hand
column, 3rd step down.
Do  I solder a piece of wire btwn the two right hand pins of P7,  and if so,
exactly where? During my attempt at installation, I damaged part P7, also
damaged part P5
with my soldering iron so I will have to order two new parts Monday. I am
concerned as to the state of the PCB board now because much of the plating
at P7 and P5
was removed/damaged. wonder how this will pan out during testing. any
suggestions are welcome.  Dennis Vavra AD5LY
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com


-- 
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.410 / Virus Database: 268.16.6/617 - Release Date: 1/5/2007