[Elecraft] K2 backup filter and other settings?

[Ron D'Eau Claire]

That sounds like a good idea Bernie if it's "do-able".  However, it's not a
big deal to write down the settings, once you've worked them out. I keep a
simple log sheet with my K2 manual that has the current settings noted.
Using pencil, it's easy to change the relevant values if I decide to change
something. 

Ron AC7AC

-----Original Message-----
My K2 (5707) is now working great, including the KPA100 amplifier, after a 
little set back due to a very small wire strand across a couple of connector

pins.  Thanks to Gary Surrency's encouragement and advice I was able to find

and correct the problem.  At one point in the process, the radio got reset
so 
that I had to redo the filter settings.  It occurs to me that with the
serial 
interface functioning, there should be a way to back up the filter settings 
to a computer and reload them if necessary.  Looking through the KIO2 
programmer's reference manual, it looks like all the commands to do that are

available, but I can't find any programs which actually do this.  Does
anyone 
know of such a program?

Bernie, W1AZ