[Elecraft] K2 - no tone on TX

[Dohn]

You were absolutely right.  I even saved that post from Don because it
seemed like a good one for my own archive.  That's pretty weird.  I just
saved it yesterday and needed it today.  Go figure.  Thanks so much.

73

Dohn N8EWY

-----Original Message-----
From: David Wilburn [mailto:dave.wilburn at verizon.net] 
Sent: Saturday, February 17, 2007 9:04 PM
To: Dohn
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K2 - no tone on TX

Don and Jeff Kinzli had this discussion yesterday afternoon.  You might 
look though those email, labeled "K2 lost sidetone", Don supplied some 
suggestions there.

David Wilburn
dave.wilburn at verizon.net



Dohn wrote:
> I did a lot of maintenance work on my K2 today.  It required tearing it
down
> board by board.  All work went well.  I buttoned it up and hooked
everything
> up.  It is transmitting on CW but there is no tone, as in dah dit, just a
> slight clicking.  It appears to be putting out appropriate poser levels
but
> is not making a tine through the speaker or in the headphones if plugged
in.
> 
>  
> 
> I suspect something silly or simple.  Any ideas?????
> 
>  
> 
> Dohn  N8EWY
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 


-- 
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.412 / Virus Database: 268.18.1/690 - Release Date: 2/16/2007