[Elecraft] Z6, grounded can?

[David Wilburn]

FB, it was just that we had grounded all the other cans, so I wasn't 
sure.  Thanks.

David Wilburn
dave.wilburn at verizon.net



Don Wilhelm wrote:
> Dave,
> 
> Congratulations on your progress.
> 
> Don't worry about the empty holes - all holes are not filled, many are via
> holes to get a signal (or ground) from the top of the board to the bottom.
> If you need to check anything else of that nature, look at the parts
> placement diagram near the end of the manual, you will find it quite
> helpful.  It does not show the holes, just the component placements.
> 
> 73,
> Don W3FPR
> 
>> -----Original Message-----
>>
>> I'm installing T6 (yes there is a god, this is the last of the toroids
>> for a little bit) and noticed a hole next to Z6.  I did not see anything
>> in the text, but the holes on either side of the can are in the ground
>> plane so I was not sure.
>> --
>>
>> David Wilburn
>> dave.wilburn at verizon.net
> 
> --
> No virus found in this outgoing message.
> Checked by AVG Free Edition.
> Version: 7.5.441 / Virus Database: 268.18.1/690 - Release Date: 2/16/2007
> 2:25 PM
> 
>