[Elecraft] KPA100 IMD Distortion Figures

[Wyn Hughes]

Thanks, Larry, those figures are in themselves impressive. Of course, a lot
depends on the mesurement equipment and conditions. Worth adding perhaps to
the Elecraft resource list.. My L-4's -33db compared to single tone (-39db
cf. pep), would in that case be the limiting factor. Maybe a good excuse for
a new rig.

73
Wyn, VR2AX
----- Original Message -----
From: "Larry Phipps" <larry at telepostinc.com>
To: "Wyn Hughes" <vr2ax at attglobal.net>
Cc: <elecraft at mailman.qth.net>
Sent: Friday, February 16, 2007 9:48 PM
Subject: Re: [Elecraft] KPA100 IMD Distortion Figures


> Take a look at the tests run by Jack, K8ZOA, using his Z90 Panadapter
> kit at cliftonlaboratories.com Click on the IMD Measurements link. He
> shows the test methodology, and results from several rigs, including his
> K2/100.
>
> 73,
> Larry N8LP
>
>
>
> Wyn Hughes wrote:
> > Hello Group,
> >
> > Has anyone measured, or have any information, regarding the 3rd/5th
order IMD performance of the barebones KPA100, based on a two-tone test?
> >
> > I have some figures for the base K2, courtesy of the ARRL review. I
might even have seen figures for the K2/100, but can't seem to locate them
at present. If anyone can also supply these figures, I would be grateful.
> >
> >
> > 73
> > Wyn, V2AX
> >
> > _______________________________________________
> > Elecraft mailing list
> > Post to: Elecraft at mailman.qth.net
> > You must be a subscriber to post to the list.
> > Subscriber Info (Addr. Change, sub, unsub etc.):
> >  http://mailman.qth.net/mailman/listinfo/elecraft
> >
> > Help: http://mailman.qth.net/subscribers.htm
> > Elecraft web page: http://www.elecraft.com
> >
> >
> >