[Elecraft] KPA100 relay K3 mistake

[Soaring Eagles]

OK,

I was so excited that I put in K3. The resistance checks all come out ok 
(except that I get 357 ohm for K4 instead of the 600 to 800 ohm range, 
which should be right with K3 installed). Is it ok to proceed with 
connecting it for the first tests with my K2? Or should I remove K3 and get 
another to put in later? I did look ahead and see the reasoning for not 
installing K3 yet, but if it's just for ease of installing the transformer 
and winding, I think I can working around that small space.

Thanks in advance for any suggestions.

Jim, WD9HBC
K2 #5757
KX1 #1517