[Elecraft] #5956 problem

[David Wilburn]

Check your display installation and the display driver (the big chip on 
the back) installation.  Make sure there were no bent pins when you 
pushed that thing in.  I know I was sweating bullets during that.  I 
assume all your other resistance checks on that chip were fine?  Did you 
check them on the pin of the chip, or on the associated pin on the back 
of the board?

David Wilburn
dave.wilburn at verizon.net



Matthew D. Pitts wrote:
> Gentlemen,
> 
> I'm at the first alignment stage and I've run into a problem. I was able 
> to get the INFO 201 message upon first power-up, but I haven't gotten 
> anything to display other than ELE on subsequent power-ups. Also, I have 
> to look at the display at an angle to see that. Any ideas on what to 
> look for? I can't proceed with the K2 itself until I finish these tests. 
> I guess it's time to build the KIO2, KSB2 and K160RX so they're ready to 
> install when I get the rest of it done.
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>