[Elecraft] K2 control software

[Gregg R. Lengling]

You have to remember that there is quite a bit in that firmware.  All the
calibration and linearization routines are in there.  Do you really want to
sit down and write code to try and set up VFO linearity, or code to properly
address the xtal filters.  This is a daunting task and I would never release
the code to something like this that must have taken hours and hours to make
work properly.  Especially seeing as the limited memory space available.
This is not a Microsoft project where a 10k program is written with 500mb's
of code and uses 150mb of memory to run. 

Gregg Lengling, W9DHI
http://forums.ham-radio.ch
http://www.milwaukeehdtv.org