[Elecraft] KPA100 Initial test problem

[Don Wilhelm]

Hank,

First off, you will see only a single 'flash' of SEC (or PRI) when changing
between the primary and secondary menus - so what you observed there is
normal.

Yes, most voltage measurements in the low millivolt range are the result of
noise/hum pickup on your DMM leads and can usually be considered as zero
voltage.

As far as your PA -- response, yes that means that the mian K2 processor
cannot detect the KPA100.  Do you have the ribbon cable connected?  Is the
ribbon cable oriented correctly?  Is the KPA100 firmware chip installed
correctly?  Check all those things, and check and re-check the soldering on
the KPA100 board - the most likely source of failure is in the soldering.

73,
Don W3FPR

> -----Original Message-----
> Page 23 asks for voltage measurements.  All are within tolerances.  U5
> pin 1 had 2 or 3 millivolt, any millivolt  measurement I considered as
> a zero voltage.
> Step on page 23 states: " tap MENU then tap DISPLAY. K2 secondary menu
> (SEC) will be flashed.
> When I perform this step I get a very brief SEC, which does not flash
> on and off. Right away after the short SEC  notice the display shows
> SLCH  OFF, the attenuators are at:  NB ANT2 PRE ATT.  When I use the
> Band +  Band - to scroll to PA menu entry I get  "PA  --".  According
> to the manual this means that the KPA100 micro-controller is not
> communicating with the K2.  Trouble shooting section does not help me.
> Can anyone come up with things to check or try out to resolve the issue.
> Any help is appreciated.
> Have a nice day, 73's Hank WA9QJH
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.432 / Virus Database: 268.17.29/673 - Release Date:
> 2/6/2007 5:52 PM
>
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.432 / Virus Database: 268.17.29/673 - Release Date: 2/6/2007
5:52 PM