[Elecraft] Heil Proset Ic with K2

[Don Wilhelm]

Jim,

All Heil Prosets are not created equal, you must be specific about the type,
but I will assume your subject line indicating the ProSet-iC is the one you
have purchased.  If that is so, and you purchased the Icom adapter from
Heil, then you simply wire your K2 mic configuration header for the Icom
pinout and attach a resistor (5600 ohms is good) from the AF pin to the 5
volt pin on the mic jack - the best location for the resistor is on the back
of the mic jack, not the header just because it is easier mechanically.  If
indeed your adapter is Icom, the resistor goes between pins 1 and 2 on the
mic jack.

73,
Don W3FPR

> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net]On Behalf Of Soaring Eagles
> Sent: Monday, February 05, 2007 12:59 PM
> To: elecraft at mailman.qth.net
> Subject: [Elecraft] Heil Proset Ic with K2
>
>
> Hi!
>
> I'm getting ready to install my KSB2 in #5757. I'm pretty sure that the
> Heil Proset will work with the standard Icom jumpers, but I'm not sure
> what, if any, resistor I'll need. Anyone have experience with this
> combination that can give me some hints?
>
> Thanks a lot!!!
>
> Jim, WD9HBC
> K2 #5757
> KX1 #1517
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.432 / Virus Database: 268.17.26/670 - Release Date:
> 2/5/2007 2:04 PM
>
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.432 / Virus Database: 268.17.26/670 - Release Date: 2/5/2007
2:04 PM