Top side screw on K2/100 Re: [Elecraft] swapping out K2 pa and qrp top

[Doug Faunt N6TQS +1-510-655-8604]

   Date: Sun, 04 Feb 2007 14:51:48 -0800
   From: Fred Jensen <k6dgw at foothill.net>

   Takes me about 5 mins ... 3 to find the phillips screwdriver, and 2 to 
   change the tops.  Be careful of the two screws in the top middle of the 
   side plates.  They screw into the heat sink and it is easily stripped.

It's very easy to actually drill and tap the heat sink from the side,
then use a 1/2" length 4-40 screw at that location.

As shipped, you're using a short #5 screw into the slot in the heatsink, and
it strips very easily.

73, doug