[Elecraft] K2 current sense problem

[Dohn]

Be advised ...... I am an amateur.  An amateur with a great deal of
experience going back and checking solders.  Checking them again and than
once again.  Without response from anyone else I would be searching the area
of the solders at or near the LCD and the vicinity.  When you are done, look
again.  Just a word from the amateur rank.

Dohn  N8EWY

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of TREVOR WATERS
Sent: Saturday, February 03, 2007 12:03 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K2 current sense problem

Hello All, 
This is my first posting so fingers crossed that I get
it right.
I am currently at stage two, testing and aligning K2
No 5914. After a few problems( poor sodering on T7)
finally got to hear something on 40 so much relief. In
the first stage test everything was ok but now when
pressing the display button to get up voltage and
current there is only the voltage showing and zero at
the current  13.7   000  so I'm a bit stuck and  would
appriciate any help. I suspect Q11 which is being
driven by U3A the LMC6482AIN but being a novice and
the k2 being my first real kit I am unsure and would
appriciate any help. By the way I am building the
basic CW version
Best 73
Trev GW4IMC 
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com


-- 
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.411 / Virus Database: 268.17.21/665 - Release Date: 2/2/2007