[Elecraft] K3: dot/dash memories

[Brendan Minish]

What would be wonderful is if elecraft could licence and implement the
logikey Comos4 firmware in full. 

I have been using the logikey keyers for years and they have all sorts
of embedded goodness that built in keyers don't normally have. This
extra functionality would be especially useful with the built in RTTY
and PSK modes 
With the K3 there are already 4 dedicated keyer buttons on the front
panel Whig would allow for all the normal logikey actions to be
supported.
If this is ever done at some stage it could be enabled on a per serial #
basis by paying an appropriate licence fee to Idiompress. 
I for one would gladly pay extra to have the full functionality of the
cmos4 built into the k3. Alternatively the Logikey implementation could
be an a small internal module with it's own PIC to run the keying
firmware.

73
Brendan EI6IZ
-- 
Don‘t complain. Nobody will understand. Or care. And certainly don‘t try
to fix the situation yourself. It‘s dangerous. Leave it to a highly
untrained, unqualified, expendable professional.