[Elecraft] K3 Calibration Problem

[Sanger, Joseph]

I had entered the crystal offset frequencies inaccurately.  I had
ignored the fact that some of the offsets were negative ... my brain
just didn't process the 'dash' as significant on the crystal filter
offsets!  once I had correct that error, everything worked perfectly.

Hope this helps, Steve.  You're in for a treat when you finish!

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Steve Zumbrun
Sent: Saturday, December 22, 2007 1:20 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 Calibration Problem

Hey, Joe.  I've just finished #176 and I'm stuck like you were with the
ERR 
TXG while trying to calibrate the transmitter in low power.  What did
you do 
to solve the Problem?  Many thanks, Steve W0SZ 

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

------------------------------------------------------------
This email message, including any attachments, is for the sole use of the intended recipient(s) and may contain information that is proprietary, confidential, and exempt from disclosure under applicable law. Any unauthorized review, use, disclosure, or distribution is prohibited. If you have received this email in error please notify the sender by return email and delete the original message. Please note, the recipient should check this email and any attachments for the presence of viruses. The organization accepts no liability for any damage caused by any virus transmitted by this email.
=================================