[Elecraft] ssb reception

[Don Wilhelm]

Tom,

Have the SSB filters been set up properly - it sounds like they have not.
Is the KSB2 option installed?  If, so, SSB FL1 must be set to OP1, 2, 3, 
4 or 5.

If you are not familiar with the K2 filter alignment procedures, there 
is information on the Elecraft website for how to use Spectrogram to 
assist with that task.  There is also information about setting the 
filters on my website http://w3fpr.qrpradio.com in part 3 of the article 
on K2 Dial Calibration.

73,
Don W3FPR

tpotts wrote:
> I am trying to receive on an early K2, and it has been several years since I
> have used one.  For some reason, I can only copy ssb when c mode is
> displayed?? When displayed U and L are fairly quite and signals other than
> code are unintelligible.  Could this be a set up issue, or something really
> stupid on my part??? Any suggestions would be greatly appreciated. Thanks,
> Tom
>
>
>
>
>
>
>
>
>
>
>
>