[Elecraft] Fw: VE1RGB Re: Lost K#/100 TX with latest FW!!!

[Gary Bartlett VE1RGB]

Here is some useful info if you should see  ERR TXF show up after you 
download 1.48/1.45.


----- Original Message ----- 
From: "Gary Surrency" <support at elecraft.com>
To: "Gary Bartlett VE1RGB" <garybartlett at accesswave.ca>
Sent: Thursday, December 13, 2007 9:33 PM
Subject: VE1RGB Re: Lost TX with latest FW!!!


> Hi Gary,
>
> Just go back into the filter menus and be sure everything is set to the 
> correct filter. See pages 43-44. The last f/w upgrade set defaults for the 
> filters which may not agree with how you have installed the filters in 
> your K3.
>
> Be sure and do all modes for FLTX to a filter such as 2.7 or 2.8kHz - 
> whichever one your K3 has.
>
> You might want to redo the TX gain calibration again too, on pages 46- 47 
> of the K3 Owner's manual.
>
> If not done, also do the REF CAL setup, using Method #2 as Method #3 is 
> not implement yet if you have the 1ppm TXCO.
>
> Hope this gets it going! :-)
>
> -- 
> 73, Gary AB7MY
> =========
> support at elecraft.com
> Elecraft Technical Support
>
> Gary Bartlett VE1RGB wrote:
>> I have just downloaded 1.48/1.45 and every attempt to transmit CW on any 
>> band leads to ERR TXF.  >>
>>    Help!!
>>
>>    Gary, VE1RGB