[Elecraft] RE: K1-4 -- No 30m band during initial tests

[Paul Barlow]

Mark,

have you set up the bands in firmware? The K1 doesn't simply "know" which
bands are which, you have to tell it. The procedure is described in "Band
Assignment" on p39 of the K1 manual.

73,

Paul M0CDP


From: "Mark Lampert (KB3OKS)" <kb3oks at gmail.com>
Subject: [Elecraft] K1-4 -- No 30m band during initial tests
To: "elecraft at mailman.qth.net" <elecraft at mailman.qth.net>
Message-ID:
	<eb287f0c0712122051wd57cc67q893eb6d1e47aa450 at mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1

Hello all,

I'm now a bit further along with my K1-4 build, and I just installed
the VFO toroid (L1) on the RF board, fired the radio up and adjusted
the winds to match the desired range. Shortly after that I was
switching through the four bands as instructed, and I noticed that my
radio is showing the following four bands: 40m, 20m, 17m, 15m ... **no
30m, and both 17 and 15!** (specifically, it displayed 7 MHz, 14 MHz,
18 MHz, 21 MHz).