AW: [Elecraft] K3 firmware DSP2 N/A?

[Koppendorfer Klaus]

DSP2 is for he 2nd Receiver

> 
> 
>         The download went fine again after in initial glitch which
> required
> removing power to shut the K3 off.  My heart skipped a beat when it
came
> back up with a dark LCD display and the red TX LED flashing.  But then
I
> realized it was reloading and all was OK.
> 
>         Just for my curiousity, the K3 Utility screen says:
> 
>                 Installed in K3       Available
> 
> MCU             01.48                  01.48
> DSP1             01.45                  01.45
> DSP2             N/A                    01.36
> (DVR)            (N/A)                 (Missing)
> 
> (  ) above is light gray...i.e. not active
> 
> What is DSP2 above and why is it "Available" but "N/A"?
> 
>                                        73,  Bill  W4ZV
> 
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com