[Elecraft] K3 Microphone Impedance

[Dave Yarnes]

I rather think a low impedence mike is generally preferred.  Note the pinout 
information on P. 13 of the manual where a low impedence mike (approx. 600 
ohms) is indicated.  However, the K3 can be used with either high or low 
impedence microphones, and that is dealt with via a menu setting.  See P. 20 
of the owners manual, left column, last paragraph.

Dave W7AQK

----- Original Message ----- 
From: "Bob" <leschyna at gmail.com>
To: <elecraft at mailman.qth.net>
Sent: Sunday, December 09, 2007 9:25 AM
Subject: [Elecraft] K3 Microphone Impedance


>I am sure that this is covered somewhere, but I can not find it. What
> impedance microphone is required for optimal performance with the K3
> and what is the permissible range?
>
> Thanks
> Bob
>
> -- 
> For Support Call
> Lakeshore, ON, Canada     (519) 997-4574
> Silicon Valley, CA, U.S.A.    (408) 916-1119
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>