[Elecraft] KAT2 ASSEMBLY MANUAL QUESTION

[John Mahon]

Hi group.

I just assembled and installed a KAT2 module into my K2/QRP #5949. It seems to be working fine.

On page 6, the 6th step instructs you to install the two standoffs onto the Control board. The illustration shows the washer between the standoff and PC board. I followed that instruction.

On page 12, the 4th step instructs you to secure the L-C board to Control board standoffs. The instruction continues "These lock washers go between the standoffs and the PC board, NOT between the PC board and screws as on the Control board."

I believe that this instruction is correct in saying that washers now go in a different position, but the wording should be reversed.

Since the step on page 6 instructs you to install the washers between standoffs and PC board and the two PC boards should be as close together as possible, the instruction on page 12 should read, "These lock washers go between the screws and the PC board, NOT between PC board and the standoffs as on the Control board."

Does this make any sense or am I just up too late?

John Mahon N2YC
KX1 #336
K2   #5949