[Elecraft] K3 problem with logging program after download upgrade

[Greg]

Buck.  Please report issues such as this to the K3Support at elecraft.com
address that was included with the radio.

I'll pass this on to our software person who designed the downloader.  This
must be associated with the new downloader as I've not seen this reported
before.

The issue of Line-In staing active through a power cycle has already been
identified and was corrected today.  It will be available
in the next FW update.

Thanks.

73
Greg
AB7R


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net]On Behalf Of K4IA at aol.com
Sent: Monday, December 03, 2007 6:54 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 problem with logging program after download
upgrade



The downloader utility did not reset the baud rate back from the 38,400  for
the download to the 4800 specified for the rig control - I know I read
somewhere it was supposed to do this.  As a result my logging program
stopped
responding to the radio.   I reset the logging program to  accept 38,400 and
now
the DxLab and the K3 are talking to each other  again.

Also, the Mic Sel of Line In stopped working.  Once I cycled through  the
other choices back to Line In, it started working again.

Craig  "Buck"
k4ia
Fredericksburg, Virginia USA




**************************************Check out AOL's list of 2007's hottest
products.
(http://money.aol.com/special/hot-products-2007?NCID=aoltop00030000000001)
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com