[Elecraft] K3 Calibration Problem

[Ed Muns]

The firmware has not been written yet for the 1PPM TCXO3-1 table
calibration, so use one of the other two methods for now.  It will still be
more stable than the standard TCXO3.  QRX for a future firmware release to
do the table entry.

73,
Ed - W0YK

> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net 
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Sanger, Joseph
> Sent: Saturday, 01 December, 2007 13:11
> To: elecraft at mailman.qth.net
> Subject: RE: [Elecraft] K3 Calibration Problem
> 
> I am trying to perform the Ref Oscillator Calibration for my 1 ppm
> device:
> 
> 
> Method 3 (1 ppm TCXO Option):
> 
> * Locate the CONFIG:REF CAL menu entry.  Tap 1 to change the 
> name to REF xxC.
> 
> * Locate the calibration data sheet, which shows frequency vs.
> temperature over a wide range.
> 
> * For each data point, tap 2 or 3 to select the calibration 
> temperature, then use VFO A to set the specified oscillator 
> frequency in Hz.
> 
>  
> and am getting nowhere fast.  In step 1, I see the 'REF CAL' 
> menu displayed by VFO B, but tapping '1' doesn't change the 
> name off the menu; it merely performs the usual 'tap' 
> function of that switch:  A/B.
> 
> 
> Thanks for any help from anyone!
> 
> ------------------------------------------------------------
> This email message, including any attachments, is for the 
> sole use of the intended recipient(s) and may contain 
> information that is proprietary, confidential, and exempt 
> from disclosure under applicable law. Any unauthorized 
> review, use, disclosure, or distribution is prohibited. If 
> you have received this email in error please notify the 
> sender by return email and delete the original message. 
> Please note, the recipient should check this email and any 
> attachments for the presence of viruses. The organization 
> accepts no liability for any damage caused by any virus 
> transmitted by this email.
> =================================
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>