[Elecraft] LED segment display reading high

[Michael Wells G7VJR]

Hi -

I have completed the RX in my K2 and found that all signals were end- 
stopping on the LED. I have recalibrated the segement hi/lo settings  
as per the manual but this procedure always results in high readings  
(eg. S5 sigs read S40). I can wind s-hi up to make the readings more  
sensible and then it all behaves correctly.

I wonder whether I have a wrong capacitor or resistor somewhere, as I  
think the calibration process is unlikely to give S40 readings in  
this way. I'm not sure where to look - any advice on this would be  
much appreciated!

73
Michael G7VJR