[Elecraft] PLL Clicks

[Kevin Shaw]

Don,

Thanks for the reply.

Unfortunately it reads 8.5 ohms. I'll have to look elsewhere.

Kevin
N8IQ


-----Original Message-----
From: Don Wilhelm [mailto:w3fpr at embarqmail.com] 
Sent: Thursday, August 16, 2007 4:13 PM
To: Kevin Shaw
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] PLL Clicks

Kevin,

Check RFC15 on the bottom of the RF Board.  You must check it with an 
ohmmeter - even if it is open you will find 5 volts on both sides of it.

Should you find it open and do not have an immediate replacement, short 
across it, replace the bottom cover and re-run CAL PLL - then check 
again for the clicks.

73,
Don W3FPR

Kevin Shaw wrote:
> My K2 has the "PLL Click" problem when I turn the VFO. I've tried running
> CAL PLL with the covers on, but no luck.
>
>  
>
>