[Elecraft] Twin Lead feedline

[Jozef Hand-Boniakowski]

I have been using TruValue twin lead at $14/100 feet for the past 4 
years on both my G5RV and my 40 meter loop.  Works just fine.  Best 
bargain around.  Since I only need 40 feet on either antenna, if it goes 
bad, I just use the other half  of what is left with some to spare.

Jozef WB2MIC

PS.  The antenna wire is leftover electric fence wire now over 22 years 
old.   Cost per antenna per year is quite low.  :)

Robert Tellefsen wrote:
> Thom
> There are various grades of 300 ohm twinlead.
> Some are very cheap and have pretty skimpy
> conductors.  Some are good quality.  There is/was
> at least one version that was suitable for transmitting
> (power level not stated that I can recall).  If you
> have some of the good quality stuff, you can probably
> do 100w just fine.  I'd watch out for the skimpy stuff,
> though.
> Good luck and 73
> Bob N6WG
>
> ----- Original Message -----
> From: "Thom LaCosta" <lacosta at bcpl.net>
> To: <Elecraft at mailman.qth.net>
> Sent: Tuesday, August 14, 2007 4:26 AM
> Subject: [Elecraft] Twin Lead feedline
>
>
>   
>> It's been years since I melted 300 ohm twin lead...
>>
>> Can I use it for a 44 foot each side of center doublet at 100 watts out?
>>     
> I
>   
>> can't find any other open wire feedline locally, and I need to get
>>     
> something up
>   
>> in the air....I keep on walking into the slinky that runs down my hallway.
>>
>> I'm thinking at 5 watts it will pass...just not sure what will happen at
>>     
> 100
>   
>> watts.
>>
>> Thanks
>>
>> 73 k3hrn
>> Thom,EIEIO
>> Email, Internet, Electronic Information Officer
>>
>> www.baltimorehon.com/                    Home of the Baltimore Lexicon
>> www.tlchost.net/hosting/                 Web Hosting as low as 3.49/month
>> _______________________________________________
>> Elecraft mailing list
>> Post to: Elecraft at mailman.qth.net
>> You must be a subscriber to post to the list.
>> Subscriber Info (Addr. Change, sub, unsub etc.):
>>  http://mailman.qth.net/mailman/listinfo/elecraft
>>
>> Help: http://mailman.qth.net/subscribers.htm
>> Elecraft web page: http://www.elecraft.com
>>     
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>