[Elecraft] KIO2 and serial keying - correction

[HEMBREE at asu.edu]

I wrote previously:
"I've done what you're talking about with CT but not N1MM."  

I haven't used CT with serial port keying for 6 years so the memory
is a little hazy.  Turns out you can't have the rig control and
keying on the same serial port with CT.  You can run them on separate
serial ports, which is what I did back then.  Once I got two K2s
I used parallel port keying.

You should still be OK with N1MM.  Make sure you are connecting your 
keying interface to pin 4 and 5 at the computer end of the serial cable 
and only pins 2, 3 and 5 are connected at the KIO2 end of the cable.

73
Gary, N7IR
K2 1078, 2154, 3463