[Elecraft] Computer interface programming

[Don Wilhelm]

Tom,

The K2/KIO2 Programmers Reference is available for download from the 
Elecraft website > 
http://www.elecraft.com/manual/KIO2%20Pgmrs%20Ref%20rev%20E.pdf

It contains all the commands and their formats.  If you create a piece 
of software that can send and receive these commands over an RS-232 
port, you will have the software that you desire.

The commands can even be sent manually or from a script using a terminal 
program such as HyperTerm.

That is about as open source as you can get. Pick your programming 
language from assembler through the most exotic and control your 
display/input presentation and the resulting serial port commands.

73,
Don W3FPR

73,
Don W3FPR

Tom Zeltwanger wrote:
> Can anybody recommend a source of any open source software or libraries 
> (preferably "C" language) for talking to my K2? I just build the KIO2 and am 
> looking at doing some custom interface programming. 
> 
> I would also be interested in seeing what complete software packages are out 
> there, but my main interest is in something I can use to start my own program, 
> or source code I can really customize. This will run on a small embedded 
> processor with a hex heyboard, so I am not really looking for a fancy GUI.
> 
> Also - is there a problem with the list? Or is everyone all talked out? I only 
> received 2 messages since yesterday aftenoon - very unusual.
> 
> 
> 73,
> 
> Tom KG3V
> 
> 
> 
> 
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>