[Elecraft] Computer interface programming

[Chris]

I think there is the code on the Elecraft web page to control the K2
----- Original Message ----- 
From: "Darwin, Keith" <Keith.Darwin at goodrich.com>
To: <elecraft at mailman.qth.net>
Sent: Friday, April 20, 2007 1:51 PM
Subject: RE: [Elecraft] Computer interface programming



I haven't looked at the set of commands to control the K2 over serial.
I seem to recall they're somewhere, right?  Is it just a simple command
/ response protocol?  Does the K2 send any spontaneous messages to the
controller?  It is probably simple enough that I'd be inclined to write
my own rather than looking for one, but that's just me.

- Keith N1AS -
- K2 5411.ssb.100 -

-----Original Message-----
From: Tom Zeltwanger

Can anybody recommend a source of any open source software or libraries
(preferably "C" language) for talking to my K2? I just build the KIO2
and am looking at doing some custom interface programming.

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com



-- 
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.446 / Virus Database: 269.5.5/769 - Release Date: 19/04/2007 
17:56