[Elecraft] rewiring a BL-2

[Dan Barker]

If there is a way to wire up the BL-2 so it's two ratios were exposed on the
input side, rather than the output side, one could run two coax from the
Ant1 and Ant2 jacks on their KAT2 to the BL-2 simultaneously. Then, the
remembered Ant 1/2 choice per band would automagically select the Balun
ratio.

I've had my K2 (#2456; KAT2, KNB2, KPSK2, K160R) for years, and just ordered
the BL-2 (to go with my new antenna). I was trying to figure out how to ease
my ailing memory, but I don't know enough about transformers. I did check
the KAT2 schematic. The non-selected antenna is open, not terminated.

For those with the skills, but not the schematic, check out
http://www.visioncomm.net/images/bl2.jpg

Dan Barker