[Elecraft] PSK31 and K2

[R. Kevin Stover]

Ron Polityka wrote:
> Hello,
> 
> I finally found my RIGblaster plus unit but I can't find my book.
> 
> Just playing around with the RIGblaster I can receive via the sound card
> with out any problems. I placed the K2 into VOX and I go to transmit and 
> all
> seems fine but it does not send anything. Then I tell the unit to receive
> but it will not receive unit I take the Mic jack out of the front of the 
> K2.
> 
> Anyone else using the K2 and RIGblaster plus for PSK31?
> 
> Onto looking for the manual.
> 
> 72 and Thanks,
> Ron Polityka
> WB3AAL
> www.wb3aal.com
> www.n3epa.org/
> 
> K1 - SN 01011
> K2 - SN 01392
> 
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 


Hi Ron.

I've got that same setup and it works great.
Get to the West Mountain website and download a Rigblaster plus manual.
You need that to double check the jumper settings inside the rigblaster 
and the cabling.

If setup properly you don't need to use VOX to transmit as the 
rigblaster will kick over the PTT through the mic cable.

Looking at the online Rigblaster plus manual and check page 8 for the 
Alinco, Kenwood, SGC, Elecraft jumper setup.

Good luck.

-- 
R. Kevin Stover	ACØH

K2/100 #4684

Reclaim Your Inbox!
http://www.mozilla.org/products/thunderbird