[Elecraft] Silly KPA100 Question

[Mike Short]

 I am currently at that point, but am using Rev. E manual. Figure 24 A1
shows the detail.
The solder lug goes on what will actually end up as the bottom of the panel,
since the circuit
Board hangs upside down on the heatsink. If you do a test fit, you will see
the lug ends up slightly
Above the circuit board. 

Mike
AI4NS

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Paul Clay
Sent: Sunday, April 01, 2007 11:36 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Silly KPA100 Question 

Respecting the placement of the solder lug on the
antenna connector J2, is the lug really supposed to be
installed on the screw nearest the top edge of the
rear panel?  Seems if its installed there it's going
to come close to interfering with the with the circuit
board to which the rear panel attaches (it can be made
to work, but it will be a tight squeeze).   Figure 22
shows the rear panel inverted; should the installation
instruction be interpreted "installed on the screw
nearest the top edge of the (inverted) rear panel"
(which is, nearest the bottom edge of the panel)?

Thanks!


 
____________________________________________________________________________
________
The fish are biting. 
Get more visitors on your site using Yahoo! Search Marketing.
http://searchmarketing.yahoo.com/arp/sponsoredsearch_v2.php
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com