[Elecraft] Connecting the K2/100 to the KAT100

[John Wiener]

Hi everyone.

I am attempting to use the KAT100 for the first time and a new  
homebrew G5RV.

Just finished the cabling and went successfully thru calibration  
steps.  Then, I put the covers on the KAT100.  When I turned on the  
K2, a click and no other response on K2, no LCD.  No LEDs on KAT100  
either.
Disconnect pwr to KAT: no change, disconnect RF between: no change,  
disconnect RS232, now all is OK on K2.  Made the obvious check of the  
cable on both ends, and repositioned the leads.

I will continue to check for shorts in the cable after I get back  
from work.  However, I thought I'd ask whether there might be  
something else to look at, as well.
I used adhesive pads on the bottom panel of the ATU.

Thanks,

John
AB8O