[Elecraft] AWG Packet Engine?

[Douglas Todd]

Can't help on the AWG engine, but I'm able to use RTTY and Slow Scan TV ( At 
least receive). I'm using the MMSCTV and MMpkt drivers. They are a sound 
card implementation.

I enabled the RTTY mode -- the 'r' mode using the secondary menu commands. 
Using Spectrogram, I set the filters fairly wide - to about 2 Khz. The 
configuration seems to work for me.

Good Luck !

Douglas Todd (KE7GYQ)


----- Original Message ----- 
From: "Bill Allen" <wallenpb at earthlink.net>
To: "'Elecraft Reflector'" <elecraft at mailman.qth.net>
Sent: Sunday, September 10, 2006 2:54 PM
Subject: [Elecraft] AWG Packet Engine?


> Has anyone had any luck using the AWG Packet Engine software for HF packet
> with their K2?  I just cannot seem to get tuned in well enough to decode
> packets.  Even on the OP1 filter, I am thinking that I am just to close to
> the edge of the bandwidth of the filter to receive.  Any ideas?
>
> 73, Bill Allen WA5PB
>
>
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com