[Elecraft] jumpers question

[John Wiener]

Hi, everyone.

I am trying to rescuscitate my K2 after some problems with K60XV.

I have decided to re-do alignment procedures.  Reason? I now realize  
my 40M receive behaves differently than other bands even with the  
K60XV removed.
I used the XG2 to cal the S-meter and could not get a reading of S9  
for the 50 uV signal.  I couldn't even hear the 1 uV sig.

So, now I am back to p. 60 of manual and re-doing the 4 MHz  
oscillator cal.
Problem: I can't access TP3 while I have KDSP2 attached.

My question: Where exactly do I place jumpers on J1 and J2 of Control  
Board?

Thanks

John
AB8O