[Elecraft] Rework Eliminators

[Doug Faunt N6TQS +1-510-655-8604]

I've found the audio filter/DSP one to be very convenient when doing work
on the front panel/control boards, since things can be tested without
having to reassemble that stack, or probed behind where it would be.

73, doug

   From: "Mike Short" <mike.short at mchsi.com>
   Date: Tue, 28 Nov 2006 19:23:28 -0600

   Tom,

   They are listed at the bottom of the Elecraft website. I put them in my K2,
   and they are great.
   What they are is a board that plugs in to the connectors for the various
   option modules, KSB2, KNB2, KAF2, etc.

   You can do them as you assemble the K2, or go back after it is finished and
   install them. They are great for troubleshooting, since all you need to do
   is unplug the suspect module and verify operation. I had an issue with my
   KSB2 board, and it was great to be able to simply unplug it. If you do not
   have the rework eliminators installed you must solder in jumpers, and other
   steps to remove a module.