[Elecraft] K1, wrong transmit freq

[Larry]

   Thanks Don,
   That was the problem. All bands are now working correctly.
   73
   Larry
   kb5dxy
   Don Wilhelm wrote:

Larry,

I assume a 4 band filter board.
Are the trimmers on the filter board set near the center point?  If not,
realign the 15 and 20 meter filters.  It is possible to align the frequency
of the higher band too high and end up with an off frequency signal.  Set
the trimmers to the center, then adjust 15 meters first and 20 meters
second.  Note that the upper two bands can be aligned independently of the
lower two bands.

73,
Don W3FPR


  

-----Original Message-----

While I am waiting for my XG2 to arrive I would like to discuss the
problem that I am experiencing. On 20M my K1 is outputting on 20.17 mhz
with gravelly tone, the is VCO set at14.00 mhz. All other bands are on
frequency  (+- a couple of K) with pure tone. Also with a 100' wire
antenna, I am receiving CW just fine on 15M, 30M and 40M. On 20M just
hiss with an occasional birdy. Output on all bands including 20M is 5W.