[Elecraft] Component ID

[Joseph Reed]

Don,

Your advice to re-inventory is correct.  But Christine has been known to have had a bad day.  In my last K2 (K2, KSB2, KIO2, KNB2, K60XV,K160RX, KAF2, KAT2, KBT2, EC2, KPA100, KAT100) I have been short shipped THREE (3) parts.

As the late Carl Sagen would say, "Billions and billions of parts."  It sure seemed that way.  Whew we are talking five nines plus!

That is phenominal.  Eric and Wayne need to add a web page to show us who some of the people who make the magic/mojo happen.

But you bet check the foam, both sides.  Even Vegas wouldn't bet, much less put a line on Christine.  

Joe N9JR

----- Original Message ----
From: Don Wilhelm <w3fpr at earthlink.net>
To: wsm at amaonline.com; elecraft at mailman.qth.net
Sent: Wednesday, November 15, 2006 11:40:43 AM
Subject: RE: [Elecraft] Component ID


Scott,

You will need the 25LC320 for the U7 slot - an LM380N-8 must go into U9.
Check all the 8 pin devices on the black foam again - Christine rarely makes
a packing mistake.

73,
Don W3FPR