[Elecraft] kpa100 with kat100-2

[Joseph Reed]

Dave,

There isn't a contradiction between what Lyle and John describe.  Lyle was taking a conservative approach to the issue.  Nothing wrong with that.  John did some extensive tests and found it wasn't necessary.  Both approaches are equally correct.

Being lazy, and after reading John's test results I decided not to replace L1.  Eight months later I can say it wasn't necessary to replace L1.

As in most things Elecraft, there are more than one way to skin the cat.  The fact that we are offered a number of choices to arrive at our desired destination is a very good thing.

Joe N9JR

----- Original Message ----
From: Dave Van Wallaghen <w8fgu at comcast.net>
To: elecraft at mailman.qth.net
Sent: Saturday, November 11, 2006 1:26:04 PM
Subject: RE: [Elecraft] kpa100 with kat100-2


Don,

Just to clarify - does this include the mod to L1 on the KIO2 AUXBUS board
as explained on the KK7P web site? I found a contradiction to this mod on
KI6WX site. (Was or is there a possible current draw problem through L1)?

Thanks in advance,
Dave, W8FGU