[Elecraft] KX-1 assembly question

[Doug Person]

Hi Don,

Thanks for your input.  I guess I'm pretty confident.  I built K2 #1920 
with all the accessories as well as a K1.  I've learned to be extremely 
careful.  I was just wondering if any of the tests and alignment 
procedures were depending on the remaining parts not being installed yet.

I'm very impressed with the design of the KX-1.  Can't wait to pound out 
my first CQ...

Doug -- KØDXV

Don Wilhelm wrote:
> Doug,
>
>   

> The real answer depends on your confidence level that you have already made
> no errors in the assembly.
> It really will not hurt anything, but it complicates matters for debugging
> if you had made an assembly error.
>
> If you ordered the trimmers already, it should take no longer than 4-5 days
> for them to arrive at your mailbox.
>
> 73,
> Don W3FPR
>
>   
>> -----Original Message-----
>>
>> I'm building a KX-1.  I just completed Assembly Part II.  Unfortunately,
>> I can't perform Alignment and Test - Part II because my kit was short
>> the two little 5-20 pf trimmers.  While I'm waiting for these parts to
>> arrive,  does anyone think there would be any issues with completing the
>> remaining assembly steps and coming back to Alignment and Test - Part II
>> later?
>>
>> Thanks,
>>
>> Doug -- K0DXV
>>
>>     
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>
>